Lightblocks Ply ‹ TABLE TOPS

Colours
Gallery
Specifications
Downloads

Texture 1 Lustre 1 Transparency 1

Lightblocks Board - Metallics

Select a variant

Click on a thumbnail to enlarge

Description / Features: Lightblocks resin laminated onto a ply substrate

Composition: Lightblocks and C/D grade ply. Supplied as a fully finished table top with a 3mm pencil round edge detail and ply substrate to fix into. C/D grade ply means that knots and imperfections are inherent in the plywood layers. If a perfect edge is required, either a better grade of ply can be used or holes can be filled using a putty. The putty will be smooth and look fine, but will be noticeable. Contact Baresque for details.

Features: Table top can be directly screwed to the base

Indoor / Outdoor: Indoor use only

Wet Areas: Yes

Sizes Available: Tops are cut from a 2400mm x 1200mm sheet. Consider the sheet size to deliver the most cost effective table top. Contact Baresque for details.

Thickness Available: 21mm = 3mm Lightblocks + 18mm ply

Finishes Available: Matt

Other Variations Available: Stained edge detail - Ash, Cherry, Chocolate, Clear

Refinishable: Fully refinishable

Lead Time: 3 weeks (approx) + 1 week for Western Australia. Express delivery may be available subject to a surcharge. Contact Baresque for details and pricing.

Additional Comments: Not suitable for use around food unless sealed

Care Instructions

* Use warm water, mild detergent, and a soft sponge, cloth, or chamois to clean LIGHTBLOCKS

* Surface contamination may be cleaned using kerosene, hexane, or aliphatic naphtha, or any acrylic cleaner, such as Novus. Always follow manufacturer's recommended use and safety procedures.

* Do not use glass cleaning products, acetone, gasoline, benzene, lacquer thinner, chlorinated solvents, gritty abrasive scouring compounds, or alkaline cleaners to clean Lightblocks as damage to the sheet will occur.

* Remove any oily residue left behind from solvent cleaning with detergent and water.

* Do not use squeegee, scraper, or synthetic rags that may scratch LIGHTBLOCKS.

* When cleaning, never scrub LIGHTBLOCKS. Gently wipe surface with a soft scratch free cloth.

REFINISHING

* Light refinishing - if there is only a light scratch, refinishing can be achieved by using rubbing the area in a random circular motion with a fine steel scouring pad (Scotch-brite). Test in an inconspicuous area before attempting a main area on the job.

* Heavy refinishing - if there is a deep gouge, LIGHTLBOCKS can be easily refinished using a random orbital sander (Makita 125 or better) and an 80 grit timber working paper. The LIGHTBLOCKS resin coat is then rubbed into the surface and buffed off using a dry, soft cloth.